Spiral Belt Trial Run Walkthrough — Shown to the Buyer Before Bulk

A walkthrough of a small radius spiral belt trial run for a project in Malaysia, made to a drawing prepared from the buyer's data and confirmed before production. Welds and rod ends were ground a second time; the video was sent with photos and samples so the buyer could approve the belt before the bulk order.

Belt
Spiral belt
Length
22 seconds
Send photos of your belt →

What you can see in this video

  • • The trial-run belt laid out
  • • Welds and rod ends after grinding
  • • Mesh and edge links close up

What this check is for

  • ✓ Smooth welds with no burrs
  • ✓ Flat mesh
  • ✓ Edge links as on the drawing

Questions about this check

Why make a trial run before bulk?
So the buyer can see welds, mesh and edge links on a real belt, made to the confirmed drawing, before the full length is made.
What was the trial run based on?
A drawing prepared from the buyer's data and confirmed before production.