Side-Driven Belt Sprocket Fit Check
A UHMWPE sprocket turned by hand along the edge of a side-driven belt before shipment. It checks that the teeth engage the belt edge where the drive will act.
- Belt
- Side-driven belt
- Length
- 4 seconds
What you can see in this video
- • UHMWPE sprocket turned along the belt edge
- • Wear strips at the edge
What this check is for
- ✓ Teeth engage the belt edge
- ✓ Pitch matches along the edge
Questions about this check
- Why check the sprocket at the belt edge?
- On a side-driven belt the drive acts on the edge, so the teeth must engage the edge where the drive will act.
- What do you need for a side-driven replacement?
- Belt width, rod pitch, edge type, turn ratio and drum details, plus photos of the drive and the old belt.
More videos
▶ 24sSpiral freezer belt
Spiral Freezer Belt Running in a Spiral Tower
▶ 24sSelf-stacking belt
Self-Stacking Belt Stacking Test Before Shipment
▶ 12sSelf-stacking belt
Self-Stacking Belt Running in a Freezer
▶ 22sSpiral belt
Spiral Belt Trial Run Walkthrough — Shown to the Buyer Before Bulk