Small Radius Spiral Freezer Belt — Project Case: Replacing the Belt on an Existing Spiral
13 pages · flip through online · tap the right half for the next page

What you will find in this book
Seen and approved before the full orderApproved from photos and samples before bulk.Open page 2 →
On a tight turn, the inner edge decides fitSame width and pitch does not mean the same belt.Open page 3 →
Malaysia · existing spiral · about 130 mIt had to run on the existing spiral like the original.Open page 4 →
Trial run measured against the drawingRead with a caliper, sent with the photos.Open page 5 →
Welds and rod ends ground a second timeThe edge is what touches your drum and guides.Open page 6 →
Turn test: laid out in a full circleIt shows how the mesh closes on the inside of the turn.Open page 7 →About this document
Replacing a Small Radius Spiral Belt — Approved Before Bulk — a 13-page project cases book from JBL Mesh Belt, to read online or download as PDF.
One real project: the drawing prepared from the customer's data, a trial run approved from photos, a full-circle turn test, then bulk.
Malaysia · 2026 · about 130 m · replacement on an existing spiral.
Photos and readings come from published JBL Mesh Belt projects; customers are not named.
Same readings on trial and bulk
| Item | Trial run | Bulk belt |
|---|---|---|
| Rod pitch | 19.05 | 19.05 |
| Pitch | 27.40 | per drawing |
| Link thickness | 2.72 | per drawing |
| Wire | per drawing | 1.60 |
Bulk ordered after the trial was approved. See page 8 →
Questions this document answers
Replacing a Small Radius Spiral Belt — Approved Before Bulk
One real project: the drawing prepared from the customer's data, a trial run approved from photos, a full-circle turn test, then bulk.
Approved from photos and samples before bulk.
Send your drawing, belt data or old-belt photos. We review the small-radius fit with you before you order.



